| The X-3D has a 3 pin connector which is compatible to the camera connector of the x-ufo mainboard. You can activate the connector of the X-3D using channel 6. You need the airplane model in order to use this function. Programming: - Goto the sub trim menu (manual page 20 [Sub Trim]) and set "FL" to "D 83". - in the menu travel adjust (S.20 [Travel Adjust]) set Flap to U 150% and D 50%. ==> the function is activated by switching "Throttle Hold, Flap/Mix" downwards. Caution: The connector has a maximum load of 20mA! |